Our Diamond Back Rougher is designed for maximum Metal Removal Rates (MRR) in Non Ferrous Applications. Although the chart below depict a maximum chip load per tooth (IPT) value, your maximum may be lower due to Machine Horsepower, Machine Torque, Toolholder and/or workholding.
The “General Operating Range” is based upon 2X diameter (ADC / DOC) in full diameter (RDC / WOC) SLOTTING. The minimum Chip Loads remain constant for all applications, however, the maximum chip loads can vary for side milling applications in Finishing, Heavy Roughing & Light roughing.
 |
| Diamond Back Rougher Chip Load range for Non Ferrous "N" type materials |
No comments:
Post a Comment